Illustration Of A Slightly Knotted Rod And Tied Line Method

The pole is a section connecting the fishing line with the hand rod. The main function is to transfer the force to other pole joints. The tip is usually bonded with a pole rope (snake mouth rope). Before binding the thread, you must first tie the pole rope to tie the pole rope, and then fix the fishing line to the pole rope. Let’s take a look at the illustration of the pole knot and the method of binding the thread!

1. Definition discussion

The rod is the first section of the fishing rod, and its importance to the rod is much greater than the tail of the rod. Its main function is to transmit the force to other rod sections. Common ones include solid rod and hollow rod. Among them, the inside of the solid rod is solid, and its toughness and strength are higher than that of the hollow rod. The inside of the hollow rod is hollow, and its weight and feel are better than that of the solid rod.

2. Knotting method

1. The first type: directly tie the rod slightly and then tighten it. This knotting method is suitable for fishing for small fish such as crucian carp.

2. The second type: wrap the rod slightly around the rod and then tighten it. This knotting method is suitable for fishing for medium-sized fish such as carp.

3. The third type: the rod is slightly cord and the rod is slightly wrapped and then tightened. This knotting method is suitable for fishing for large fish such as grass fish.

3. Tie binding method

1. Step 1: Use your thumb and index finger to wind the main line into two rings, and then use your fingers to fix the loop of the main line into.

2. Step 2: Pass the rod slightly through the winding ring, gently tighten the main line so that the main line is firmly fixed to the rod.

3. Step 3: Move the space bean up and hold the main line slightly on the rod. When you take the line, move the space bean down and pinch the thread and pull it out.

4. Correct usage

1. When tying the thread, break the rod slightly: When tying the thread, avoid breaking the rod slightly. The correct way is to pull the rod slightly out 20 to 30 cm and tie the main line. Do not pull out all the rods and then tie the main line. You should not tie the main line just after pulling out the rod to the red rope position.

2. When adjusting the float, break the rod slightly: When adjusting the float, pay attention to protecting the rod slightly. It is best to retract the fishing rod first or place it on the flat ground and then adjust the float seat. Do not directly pull the rod slightly and then pull the float seat. If you are not careful at this time, you will either break the rod slightly or break the fishing rod.

3. Broken the rod when lifting the rod: Do not use too much force when lifting the rod. Some newbies often lift the rod violently after seeing fish eating bait. This way, the fishing rod is easily broken due to sudden stress, especially when lifting the rod like this, most of the line or the rod will be broken.

4. When stalking fish, break the rod slightly: Don’t be too rush when stalking fish. Be sure to completely turn the fish over and then use a copy net to get ashore. Some novice will vigorously carry the rod back when stalking fish. At this time, a slightly larger fish may break the rod or the second part of the fishing rod.